BVC Atomiser for smaller Aspire tanks

Aspire


£1.20




What is it?

A replacement atomiser for the K1, CE5S and ET-S clearomiser. The advantage of replacing the coil in clearomisers is that they can be cheaply rebuilt to refresh your vape.

Inside each atomiser is a dual bottom vertical coil (BVC) in 1.6ohm resistance.  

Atomizers like the filaments in old lightbulbs occasionally blow.  The old atomizer can be unscrewed and a new one screwed in to refresh your vape. If an atomizer does not seem to be working so well, you may wish to attempt to clean it before replacing it. Remove the used atomizer gently, soak it in strong alcohol and then warm water. Once it has thoroughly dried, it may perform better when returned to your clearomiser.

 

How to use

  1. Unscrew the base from your CE5S or ET-S clearomiser.
  2. Unscrew the used atomiser from the base.
  3. Screw the new atomiser in place on the base.
  4. Fill clearomiser in accordance with instructions for CE5S or ET-S.

 

Troubleshooting

If the draw feels too tight, there may be liquid blocking the central airtube. Unscrew the clearomiser from the battery and blow through the clearomiser onto a tissue. This should clear any blockage.

Remember to always give the atomiser enough time to soak prior to use so that it does not dry burn and give a bad taste. Covering the airholes and sucking on the drip tip at the same time can assist in moving liquid to the coils to prevent this.  


Share this Product