1 x RX2/3 mod with backcover for 3 cells
1 x Backcover for 2 cells
1 x USB to Micro-USB lead
N.B. This device needs 2 or 3 x 18650 mod batteries (sold separately) to operate.
The RX2/3 provides a powerful and versatile option. Able to operate with either two 18650 batteries or three 18650 batteries, it can be swapped between these modes by exchanging the backcover using the release button on the base. Thus the device gain size, power and capacity or swap them for compactness on a whim. It measures 40.2 x 34.5 x 88.7mm or 40.2 x 50.1 x 88.7mm depending on the backcover used.
The smooth contours of the mod fit into the hand's cradle comfortably. A micro-USB port on the front allows charging or firmware updates so you always have the latest abilities from the chipset.
The power range goes up to 150W with 2 cells or 200W with 3 cells. It can use coils as low as 0.1ohm (or 0.05ohm in TC), only the most extreme users will need more than this device can provide. Temperature control mode allows you not just to select their power but also the temperature you wish the coil to heat up to. With compatiility for stainless steel, nickel, and titanium coils, and a large easy to read OLED display, the mod is easy to use and versatile.
Atop the device is a sunken 510 connector that allows almost all large atomisers to connect without additional connectors.
How to use the RX2/3
- Press the fire button 5 times to turn on.
- Select the desired power setting using the up and down buttons.
- Screw the tank directly to the top.
- Hold the fire button to activate the atomiser and draw in vapour whilst holding.
- To lock the device fully, press the fire button five times.